Echo EA-410 - Manual (Page 12)

12 X7504220703
© 10/2013 ECHO Inc.
DESCRIPTION EA-410
1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter, and
Auger Gear Case.
2. STOP SWITCH - "SLIDE SWITCH" mounted on top of the throttle handle. Move switch FORWARD to
RUN, BACK to STOP.
3. SUPPORT HANDLE - Used for support grip by Operator during one-man operation.
4. PTO SHAFT - Power Take-Off Shaft provides power to Auger accessory.
5. AUGER ASSEMBLY - Connects to PTO Shaft. Auger Assembly is purchased separately as an
accessory. See page 10 for list of auger accessories.
6. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITH CATALYST -The muffler or
catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing
particles of carbon from leaving the muffler. Keep exhaust area clear of flammable debris.
7. FUEL TANK - Contains fuel and fuel filter.
8. RECOIL STARTER HANDLE - Pull handle slowly until starter engages, then quickly and firmly. When
engine starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
9. FUEL TANK CAP - Covers and seals fuel tank opening.
10. PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging
air from the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return
line. Pump purge bulb an additional 4 or 5 times.
11. AIR CLEANER - Contains replaceable filter element.
12. CHOKE - The choke control is located at the rear of the air cleaner housing. Move choke lever to Cold
Start ( ) to close choke for cold start. Move choke lever to “Run” ( ) position to open choke.
13. AIR DEFLECTOR - Deflects hot engine cooling air away from operator.
14. GEAR CASE - Sealed Gear Case provides 30.2 to 1 reduction for best combination of power and auger
speed. Requires no user maintenance.
15. THROTTLE HANDLE - Contains main operator controls- Throttle Trigger, Stop Switch, and Throttle
Trigger Lockout.
16. THROTTLE TRIGGER LOCKOUT - Operation of the throttle trigger is prevented unless throttle trigger
lockout lever is engaged.
17. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press
throttle trigger gradually for best operating technique..
18. DECOMPRESSION BUTTON - Push button to assist starting. Automatically resets after engine starts
and runs.
19. LOWER SUPPORT HANDLE - Used for support grip by Operator during two-man operation.
20. SPARK PLUG - Provides spark to ignite fuel mixture.