ADS-TEC IPC1300 - Manual (Page 12)

IPC1300 11
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
3.4 Mounting procedure
Use the drilling template to drill holes according the mounting illustration in the control panel with the specified
threading. Insert the upper screws half way into the control panel and hang the device on the mounting links.
Tighten the screws and insert the rest of the screws.
Warning:
The device must be switched off before connecting or disconnecting any cables in order to
prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. Make sure to meet the permissible voltage
requirements for this device.
After switching off and before switching on you must wait for at least 5 seconds.
Note:
The device is connected to the power supply using a lead out terminal with a screw
connection. A ground connection does not have to be made, because the
grounding conductor of the device plug or supply connection serves this purpose. If
additional grounding conductors are attached to a grounding screw, a wire
diameter of at least 2.5 mm² is specified.