ADS-TEC IPC1300 - Manual (Page 9)

IPC1300 8
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
3 Mounting
3.1 Mounting options
The device is intended for installation on control panels. If the device is mounted somewhere else, then the
required ambient conditions should always be provided.
Warning:
The device must be switched off before connecting or disconnecting any cables in order to
prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. Make sure to meet the permissible voltage
requirements for this device.
After switching off and before switching on you must wait for at least 5 seconds.
Note:
When selecting the mounting housing, the overall performance of the system
including built‐in cards has to be observed. The housing has to be calculated
correctly, that the max. permissible ambient temperature is not exceeded.