ADS-TEC IPC1300 - Manual (Page 17)

IPC1300 16
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
6.4 USB‐Interfaces
The USB interfaces are used for connecting peripherals with USB connection. The interface complies with the
USB 2.0 standard.
Pin‐Nummer Signal‐Name
1 VDC
2 D ‐
3 D +
4 GND
Hinweis:
The USB interfaces may be locked using the Lock USB software tool. You'll find this
software and the documentation on the service CD.
Pos: 30 /Datentechnik/Schnittstellen/PS2/Kombi Buchse für VMT 60xx @ 2\mod_1268840073235_6.doc @ 7482 @ Pos: 31 /Datentechnik/Schnittstellen/Netzwerkanschluss RJ45/Netzwerkanschluss RJ45 für VMT60xx @ 2\mod_1260451135970_6.doc @ 6856 @
6.5 Network conncetion (RJ45)
If the drivers required for functioning are installed on the device, the control system may be integrated in an
Ethernet network supporting the 10/100/1000 Mbit standard by using the Ethernet 10/100/1000BaseT network
connector. Specifications of this network topology must be observed in this case. You can install the drivers
required for functioning from the enclosed service CD, should they not be installed on the device.
Pin‐Number Signal‐Name
1 TX +
2 TX ‐
3 RX +
4 NC
5 NC
6 RX ‐
7 NC
8 NC
Pos: 32 /Datentechnik/Schnittstellen/Funknetzwerkkarte/Funknetzwerkkarte für VMT 6000 Serie @ 2\mod_1260517076470_6.doc @ 6872 @ Pos: 33 /Datentechnik/Schnittstellen/Serielle Schnittstelle COM RS232/Serielle Schnittstelle COM (RS232) für VMT 60xx @ 1\mod_1246373571514_6.doc @ 5876 @