ADS-TEC MCR5000 - Manual (Page 10)

Industrial PCs MCR5000
10
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
2 O PERATING INSTRUCTIONS
This device contains electrical voltages and extremely sensitive components. The
manufacturer or a service partner authorised by the manufacturer should be consulted if
you plan to make any modifications. For this type of work, the device must be switched off
at the mains and the power lead must be disconnected. Suitable measures for avoiding
electrostatic discharge towards parts of the components when touching the equipment
must be taken. If the device is opened by an unauthorised person, hazards for the user
might arise and any warranty claim will cease.
G
ENERAL INSTRUCTIONS :
• All users must read this manual and have access to it at all times.
• Installation, commissioning and operation may only be carried out by trained and
qualified staff.
• The security instructions and the manual itself must be observed by all persons
who work with this device.
• At the location of use the valid guidelines and regulations for accident prevention
must be observed.
The accident prevention regulations according to the "BGV C1" Accident Prevention
& Insurance regulation must be observed, in particular.
• The manual contains the most important instructions on how to use this device in
a safe way.
• Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
Warning:
Any leads (e.g. power leads, interface cables) may only be connected if the device is
switched off in order to avoid damaging the device.
2.1 O
PERATING LOCATION
The MCR 5000 model is designed for use with a monitor. You have to take care that the
environmental conditions specified in the "Technical data" chapter are met. Using the
device in non-specified environments, like e.g. onboard of ships, in areas that might
contain explosive gases or in extreme heights is prohibited.
Warning:
This device may only be switched on after the required ambient temperature is reached in
order to avoid condensate accumulation. The same applies if the device has previously
been exposed to extreme temperature variations.
To avoid overheating: The device must not be exposed to direct radiation by sunlight or
any other light or heat source.
2.2 D AMAGES DUE TO I MPROPER U SE
Should the service system have evident signs of damages incurred e.g. due to wrong
operation or storage conditions or due to improper unit use, the unit must be
decommissioned or scrapped. Ensure that it is safe from accidental re-implementation.