AiM MXL - Manual (Page 17)

MXL
User manual
Release 1.24
2 2
2.7 – How to connect MXL to the GPS Module
MXL can be connected via CAN bus with AIM GPS lap timer. It allows to record lap
and split times with no need of infrared transmitter/receiver. Connection has to be
made following these instruction:
• MXL Strada/MXL Pista: connect the GPS to 5 pins female 712 Binder
connector on the back of the logger (pin 1 = CAN+ ; pin 4 = CAN-)
• MXL Pro/MXL Pro05: connect the GPS to 22 pins Deutsch type connector on
the back of the logger using the proper cable labelled CAN Exp (pin 1 = CAN+;
pin 4 = CAN-).
Refer to:
• Appendix “A.1” for further information concerning the loggers pinout;
• logger wiring user manuals for further information concerning MXL wiring;
• GPS Module user manual for further information concerning its installation on
the vehicle.
The figure below shows a CAN network where MXL is connected also to GPS
Module. In case Data Hub is not available, plug the Module directly into MXL as
explained before.
www.aim-sportline.com 16