AirLive ePhone-1000S - Manual (Page 14)

- 14 -
Configuring Network Settings
Network settings allow the AirLive ePhone-1000 to connect to a specific network
environment.
DHCP
is the default setting for the AirLive ePhone-1000. This setting enables internet
connections with any DHCP environment.
If either PPPoE or Static IP are used, change the default network setting of AirLive
ePhone-1000
to one of these network environments.
Using the keypad you can select DHCP, Static IP or PPPoE for your network environment
Each of these three options is described below.
Configuring for DHCP
Connect the power adaptor of AirLive ePhone-1000 and connect the PPPoE network
to the RJ-45 port.
Press 1, 2, 3, 4, # (Hold the “#” key)
Enter a [Password]
Press 1, 2, 3, 4 and Enter Æ Network Settings appears.
Press Enter Æ enter the [iptype]
Press SPD/Hold
When the Blinking Cursor appears press 1 and press Enter (1 sets the networking
settings to DHCP).
Configuring for Static IP
Connect the power adaptor to the AirLive ePhone-1000
Connect the PPPoE network to the RJ-45 port.
Press1, 2, 3, 4, # (Hold the “#” key) →enter a [Password]
Press 1, 2, 3, 4 and Enter→ Network Settings appears.
Press Enter→ [iptype] →
Press SPD/Hold→ a Blinking Cursor appears