AirLive ePhone-1000S - Manual (Page 29)

- 29 -
service addr
Enter the IP address or domain name of the server according to the protocol used:
H.323 protocol:
If the Use Service option is checked, enter the IP address or the domain name
address of the gatekeeper.
If the Use Service option is not checked, enter the IP address or the domain name
address of the voice gateway.
SIP protocol: If the Use Service option is checked, enter the IP address or domain
name of the SIP Proxy Server in this field.
service id Enter a service ID required by the system.
nat traversal
When using a private IP to traverse the NAT, select one of the conditions from the
drop down list:
disable
When AirLive ePhone-1000 is using public IP, please choose disable.
When AirLive ePhone-1000 is using SIP protocol, and using the Outbound Proxy,
please choose disable
enable
. If your AirLive ePhone-1000 is using a private IP, select enable. This
automatically checks the Public IP of the NAT router and the nat address will
automatically activate. Without a special request, enter the nat address 0.0.0.0 in the
nat addr field and configure the port on the NAT router accordingly.
stun
STUN helps the SIP traverse the NAT and locates a public IP address and the type
of NAT service for the AirLive ePhone-1000. If this option is selected, enter the IP
address of the STUN server in the nat addr field.
When using H.323, select Citron if the service provider did not provide related
information
nat addr
When nat traversal or stun is enabled, enter the IP address of the NAT Proxy.
Otherwise, keep this field as 0.0.0.0.
nat ttl
Defines the amount of time, in seconds, a NAT traversal message is sent to the NAT
server. The default setting is 30 seconds.
phone number
If H.323 or SIP protocol are used, enter the phone number of the AirLive
ePhone-1000.
account
If H.323 protocol is selected , enter the H323 ID or H.235 account number.
If you select a prefix in the use dialplan drop-down menu, enter the IS card number,
and “#”.