AirLive ePhone-1000S - Manual (Page 30)

- 30 -
For example 14589653185#.
If SIP protocol selected, enter the SIP Proxy account number.
pin
If H323 protocol is used to logon the gatekeeper, enter the password or H.235
authentication password.
If SIP protocol is used to logon SIP Proxy Server, enter the password into this field.
If a prefix is selected in the use dialplan drop-down menu, enter the by ISR card
password number, and “#”. For example 3185#.
register port
If H.323 protocol is used,
If Gatekeeper is used, the register port works as the gatekeeper’s monitor port. The
default value is 1719.
If the Gatekeeper is used, the register port works as the end point device or the
Gatekeeper’s monitor port. The default value is 1720.
If SIP protocol is used, the default setting is 5060.
signal port
If H.323 protocol used, this port is mapped to the Q.931 port. Q.931 calls usually
use TCP protocol. The value can be set between 1024 and 65535.
control port
If H.323 protocol is used, the control port is the H.245 port using TCP protocol.
H.245 protocol defines the call control signal and uses TCP protocol. The value can
be set between 1024 and 65535.
If MGCP or SIP protocol is used, there is no specific request for this port. You can
enter any number.
※If many AirLive ePhone-1000s are active on the NAT at the same time, each
AirLive ePhone-1000 cannot be configured to the same port.
register ttl
Defines the number of seconds a register message is sent to the server. The default
setting is 60.
rtp tos
Enter the TOS segment of the IP header used by RTP digital follow. For detailed
information refer to IP protocol.
rtp port
RTP port is the port transferring and receiving voice flow using UDP protocol. Enter
an even number in this field between 1024 and 65535.
local type
When H.323 protocol is used, this parameter refers to how AirLive ePhone-1000
logs in to Gatekeeper or the SIP Proxy server. Enter the following values.
Phone number
Enter a phone number that corresponds to the E.164 and H.323 ID to login to the
Gatekeeper.