AirLive MD-720 - Manual (Page 56)

10. System
AirLive MD-720User’Manual 51
2. IP Address Filter
Once it was enabled, the listed IP address are allowed or denied access to the product.
Add the IP Address that you’d like to allow or deny, and select allow or deny from the list
and save it.
3. HTTPS
HTTPS is a URL scheme used to indicate a secure HTTP connection. It is syntactically
identical to the http:// scheme normally used for accessing resources using HTTP. Use an
https: //URL/ with a different default TCP port (443) and an additional encryption /
authentication layer between the HTTP and TCP. You can use the IP camera through
HTTPS easily by using https:// instead of http://.
z
Create & Install: Create a self-signed certificate for HTTPS to recognize.
z
Installed Certificate: Display or remove the properties of the installed certificate.
z
HTTPS Connection Policy: Set HTTPS connection policy for different level of
users.
To use the HTTPS encryption, please set up “Create self-signed certificate” for the first
time you use the HTTPS function, and then set up the connection policy for different
users.
Note: When HTTPS with RTSP is enabled the “on” mode, the IP Camera only
protect the setting such as username and password, and do not protect video and
audio. When HTTPS with RTSP is enabled the “off” mode, the IP Camera will
protect all setting including video and audio.
10.4 Network Basic
Please refer to Chapter 6.2.
10.5 Network Advanced
1. RTSP
- General
z
RTP Port Range: The default value of port range is 5000 ~ 7999 and it can be
changed from 1124 to 65534.
z
RTSP Port: The default value is 554. If the IP Cameras are connected with router
and installed outside over 2 sets, all of them are need support RTSP. Please fill
the value in the blank space in the range from 1124 to 65534.
z