Allen&Heath WZ 20S USER GUIDE - Manual (Page 17)

WZ20S User Guide 17
User Connector Options
SYS-LINK OUT
(option) (user connections)
REMOTE
SYS-LINK OUT
(option) (user connections)
REMOTE
SYS-LINK OUTPUT The console is supplied with a blank plate fitted here. An optional
kit of parts is available to install a 25 pin D-connector and circuit card which provides all
console outputs on a single connector. This is convenient when connecting the WZ20S
as an expander to another console. For example, the WZ20S can be used as a compact
effects submixer linked to a larger FOH console. Use a standard 25 pin one-to-one
shielded cable to plug this output into any ALLEN & HEATH console fitted with SYS-LINK
input. SYS-LINK operates unbalanced at –2dBu and is not intended for long cable runs.
Note that SYS-LINK input is not available on the WZ20S. Contact your ALLEN & HEATH
agent for further details.
USER CONNECTOR The console is supplied with a blank plate fitted here. A 25 pin D-
connector may be installed and custom wired to satisfy the particular requirements of the
application such as a broadcast or club system. For example, switched faders could be
fitted to the console and wired to this connector to provide remote fader start for control of
music and jingle players. An optional switched fader kit is available from ALLEN &
HEATH. The installation of this connector should be carried out only by qualified
personnel. Contact your agent for further details.