Allen&Heath WZ 20S USER GUIDE - Manual (Page 3)

WZ20S User Guide 3
Important Safety Instructions
WARNINGS
- Read the following before proceeding :
ATTENTION: RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR
Read instructions : Retain these safety and operating instructions for future reference.
Adhere to all warnings printed here and on the console. Follow the
operating instructions printed in this User Guide.
Do not remove covers : Operate the console with its covers correctly fitted. Disconnect mains
power by unplugging the power cord if the covers need to be removed
for setting internal options. Refer this work to competent technical
personnel only.
Power sources : Connect the console to a mains power only of the type described in
this User Guide and marked on the rear panel. Use the power cord
with sealed mains plug appropriate for your local mains supply as
provided with the console. If the provided plug does not fit into your
outlet consult your service agent for assistance.
Grounding : Do not defeat the grounding and polarisation means of the power cord
plug. Do not remove or tamper with the ground connection in the
power cord. This equipment must be grounded (earthed).
Power cord routing : Route the power cord so that it is not likely to be walked on, stretched
or pinched by items placed upon or against it.
Water and moisture : To reduce the risk of fire or electric shock do not expose the console
to rain or moisture or use it in damp or wet conditions. Do not place
containers of liquids on it which might spill into any openings.
Ventilation : Do not obstruct the ventilation slots or position the console where the
air flow required for ventilation is impeded. If the console is to be
operated in a rack unit or flightcase ensure that it is constructed to
allow adequate ventilation.
Heat and vibration : Do not locate the console in a place subject to excessive heat or
direct sunlight as this could be a fire hazard. Locate the console away
from any equipment which produces heat or causes excessive
vibration.
Servicing : Switch off the equipment and unplug the power cord immediately if it
is exposed to moisture, spilled liquid, objects fallen into the openings,
the power cord or plug become damaged, during lightening storms, or
if smoke, odour or noise is noticed. Refer servicing to qualified
technical personnel only.
Installation : Install the console in accordance with the instructions printed in this
User Guide. Do not connect the output of power amplifiers directly to
the console. Use audio connectors and plugs only for their intended
purpose.
CAUTION