Allen&Heath WZ 20S USER GUIDE - Manual (Page 9)

WZ20S User Guide 9
Specifications
0dBu = 0.775 Volts rms +4dBu = 1.23V rms
0dBV = 1 Volt rms -10dBV = 316mV rms
Console Specifications
Maximum output level XLR +26dBu into >2k ohm load
TRS jack +21dBu into >2k ohm load
Internal headroom Channels +21dB
Mix to output +23dB
Peak indicators Turn on 5dB before clipping
Meters MIX 1,2 / MONITOR Peak reading 12 led 3 colour
Frequency response +0/-1dB 20Hz to 50kHz
Distortion < 0.006% THD+noise measured at +14dBu 1kHz
Crosstalk < 90dB Channel shutoff measured at 1kHz
Noise Measured rms 22Hz to 22kHz
MIC EIN -128dB referred to 150 ohm source
Residual output noise XLR -90dBu (-94dB S/N)
TRS jack -94dBu (-94dB S/N)
Mix noise, ch routed XLR -86dBu (-90dB S/N)
TRS jack -90dBu (-90dB S/N)
Power Supply
Internal switch mode power unit with auto sensing mains input.
MAINS IN socket IEC 3 pin
Power lead Country dependent with moulded mains plug supplied
AC mains 100 to 240V AC @ 50/60Hz
Consumption 35W max
Mains fuse rating 100-240V AC T500mA 20mm
Dimensions and Weights
The connector pod can be rotated and fixed in one of two positions to allow either
desktop operation with rear facing connectors, or 19” rack mounting with underside
connectors in 10U space.
Width Height Depth
Desktop 483mm (19”) 192mm (7.6”) 530mm (20.9”)
Rack mounted 483mm (19”) 444mm (17.5”) 10U 135mm (5.3”)
Packed 590mm (23.2”) 260mm (10.2”) 610mm (24”)
Unpacked Packed
Weight 10kg (22lbs) 13kg (29lbs)