Allen&Heath ME-1 - Manual (Page 28)

User Guide – AP8997_2 28 ALLEN & HEATH
9.
Reference
9.1 Working with USB keys
We recommend that you start with a
reformatted USB key.
Check the key - Plug in and check that the
key is recognised by the ME-1. To do this
press the Recall key. The screen should
display a list of presets already on the key or
the following message if blank:
Folders - ME-1 automatically creates folders
in the root directory of the USB key when it is
plugged in:
ME1CFG For configuration files
ME1PST For presets
Files - Config and preset files have the same
.ME1 extension and must therefore be placed
in their correct folders if you copy them
between computer and USB key.
Files can be identified by their size:
Preset
= 4KB
Config = 72KB
The files are not time stamped as ME-1 does
not have a built-in clock.
File names – ME-1 uses 8.3 short file names.
It will not recognise file names longer than 8
characters. It will convert lower case
characters to upper case.
ABCD5678.ME1
Therefore if you wish to rename files on your
computer before transferring them to ME-1
mixers make sure the names are no longer
than 8 characters and comprise the following
character set:
0-9, A-Z, space
9.2 To Reset the ME-1
To perform a hard reset:
Hold down the Shift + Recall + Master keys
and power up the mixer. Release the keys
once the following screen appears. Confirm
to reset the mixer.
Resetting the ME-1:

Assigns all keys to Auto Mode

Assigns all keys for preset Store/Recall

Assigns all key names to default

All levels off, pans mid, mutes off

All presets blank (cleared)

Config name = DEFAULT

Unit name = default (MAC address)
9.3 Specification
Stereo Out – Stereo ¼” and 3.5mm jacks for:
Headphones >16 Ω , power 300+300mW
into 100 Ω load, or line out max +21dBu
Mono Out – Balanced TRS jack, nom 0dBu,
max +18dBu
Aux Input – Stereo 3.5mm jack, nom -8dBu,
max +10dBu, impedance >10kΩ
Residual Output Noise - -95dBu (level min)
Freq Response - +0/-1dB 10Hz to 20kHz
Mains Power Unit – 100-240V AC 50/60Hz,
+12V DC 1.25A out
PoE Requirement – 10W at ME-1 (We
recommend 15W at PoE hub)
Dimensions – Width x Depth x Height
225 x 150 x 55mm (8.9” x 5.9” x 2.2”)
Weight – 900g (2lbs) inc phones hook
Recall:
+Press a key
No USB Presets
Reset System?
This will clear all!
OK
Cancel