Allen&Heath ZED-R16 - Manual (Page 19)

Allen & Heath 19 ZED-R16 User Guide
STEREO INPUT CHANNEL
4
Stereo Balance control
The balance control adjusts the relative levels of the left and right sig-
nals to the main stereo bus.
-15 +15
HF
12k
-15
LF
+15
80Hz
+6
AUX1
PRE
O O
+6
AUX2
PRE
O O
BAL
L R
=
10
-30
-20
-5
0
5
-10
O O
LEV
PFL
L-R
Auxiliaries 1 & 2
Each of these controls sends a mono signal to an auxiliary bus (a sum of
the left & right inputs). The signal is sourced pre-fade which means that
the level is independent of, and unaffected by the master level control
The control varies the signal level to the bus from off (fully attenuated)
to +6dB, with unity gain at the arrow.
There are master level controls for all of the Aux outputs situated in
the master section of the mixer.
Level control
Adjusts level of the left & right signals sent to the main L-R mix bus.
There is 10dB of gain at the clockwise setting.
PFL
The pre-fade-listen switch sends the stereo signal to the PFL bus (in
stereo) and activates the PFL monitor system in the master section.
This allows the stereo channel signal to be checked before the master
Level control.
L-R Routing Switch
Press this switch to send the stereo channel signals to the main L-R bus.
For best performance, if the signals are not required or the channel is
not in use, then leave the switch in its up position.
4
5
7
6
8
5
7
6
8