Allen&Heath ZED-R16 - Manual (Page 22)

Allen & Heath 22 ZED-R16 User Guide
MASTER SECTION
Control Room Monitor jack sockets
Standard 1/4” (6.25mm) Jack socket for connecting powered monitor
speakers or an amplifier for the engineers control room monitor
speakers. Impedance balanced. Wired Tip=Hot(+), Ring=cold (-),
Sleeve=Chassis.
CRM L
CRM R
ALT L
ALT R
2 TRACK 1 IN
L
R
2 TRACK 2 IN
L
R
L
+16
-6
-9
-20
-30
-16
-12
-3
0
+3
+6
+9
R
+16
-6
-9
-20
-30
-16
-12
-3
0
+3
+6
+9
PFL/AFL ACTIVE
2 TRACK DUB
2 TO 1
1 TO 2
TALK
LEV
TALK
TO STUDIO
TO AUX 1 & 2
MIN MAX
POWER
2 TRACK 1
REPLACE L-R
8
1
2
3
4
5
6
7
1
2 Alternate Monitor jack sockets
Standard 1/4” (6.25mm) Jack socket for connecting powered monitor
speakers or an amplifier for an alternative set of speakers to the main
CRM speakers. Typically these would be nearfield monitors or speak-
ers in close proximity to the engineer.
Impedance balanced. Wired Tip=Hot(+), Ring=cold (-),
Sleeve=Chassis.
3 2 Track 1 Input phono sockets
Standard RCA phono sockets for unbalanced stereo sources. Useful
for connecting equipment with stereo analogue outputs such as CD
players and DAT machines for playing backing music, copying from
one machine to another or simply listening to that machine.
2 Track 2 Input jack sockets
Standard 1/4” (6.25mm) Jack socket for connecting balanced or unbal-
anced stereo sources. The 2 Track 2 inputs are available to be
switched to the 2 Track 1 (main xlr) outputs for dubbing or copying
purposes.
4
Main meters
The main stereo 12 segment peak response slow decay meters are fed
with the control room monitor signal (pre CRM Level). The selection
switches for the CRM source are located below the Phones Level
control and is over-ridden by the PFL or AFL signal if any listen switch
is pressed.
5
PFL/AFL Active LED
Illuminates when any PFL or AFL switch is pressed. It indicates that
the meters will show the PFL or AFL signal, or the mix of signals if
more than one switch is pressed.
6
2 TRACK DUB switches
Allow dubbing or copying from one stereo source to another.
If 2 to 1 is pressed then 2 Track 2 input jack sockets will be routed to
the 2 Track 1 output xlr’s.
If 1 to 2 is pressed then 2 Track 1 input phono inputs will be routed
to the 2 Track 2 output jacks.
7
2 TRACK 1 replace L-R switch
If this switch is pressed the main L-R mix is replaced by the 2 Track 1
input. The switch is situated before the insert points in the signal path,
so any inserted processing will still have effect, as will the main L-R
faders.
8