Autoquip Q-LIFT - Manual (Page 6)

6
2. SPECIFICATIONS
2.1 Q-Lift Models
2.2 Lift Specifications
Only standard models are shown in the specification table, there are many custom designs whose
specifications may vary from these. Please consult the specific General Arrangement (GA) Drawing to
obtain the specifications for application-specific designs.
2.3 Load Capacity
Load capacity rating is stamped on a metal plate attached to lift. This figure is a net capacity rating for
a lift furnished with a standard platform. If optional items are installed on lift after leaving manufacturer,
deduct weight of these from load rating to obtain net capacity.
Do not exceed rated capacity of lift. Loading lift beyond its rated capacity is unsafe, will shorten
operational life of lift, and will void warranty.
2.4 Unbalanced Loading
The stabilization provided is basically for balanced loads. If special attachments extend beyond the
length and/or width dimensions of platform, end and/or side load capacity is reduced 2% for each one-
inch extension from center. If load is rolling onto platform (in any but fully-lowered position) end and/or
side load capacity is reduced by dividing the rated end/side load by 1.50 to establish an available
“axle” load.
Model Cap.
(Lbs.) Travel
(In.) Raised
Height
(In.) Base
Frame
(In.) Max
End Or
Side
Load
(Lbs.) Std Min
Platfor
m (In.) Max.
Platform
(Optional
Extra In.) Raise
Time
(sec) No
of
Cyl Ship
Wt.
(Lbs.)
54Q15 1500 54 61 30 x 42 1500 30 x 42 48 x 72 16 1 935
54Q35 3500 54 61 30 x 42 2000 30 x 42 48 x 66 31 2 1000
54Q50 5000 54 61 36 x 42 2500 36 x 42 48 x 60 44 3 1100
65Q12 1200 65 72 30 x 50 1200 30 x 50 48 x 78 16 1 1000
65Q25 2500 65 72 30 x 50 1500 30 x 50 48 x 78 31 2 1075
65Q40 4000 65 72 36 x 50 2000 36 x 50 48 x 72 44 3 1190
74Q10 1000 74 81 30 x 56 1000 36 x 56 48 x 84 16 1 1050
74Q20 2000 74 81 30 x 56 1500 30 x 56 48 x 78 31 2 1125
74Q35 3500 74 81 36 x 56 2000 36 x 56 48 x 72 44 3 1240