Autoquip COMPACT LIFT - Manual (Page 22)

22
SHIMMING & ANCHORING LIFT TO CONCRETE (Anchors by Others)
Recommended concrete anchor bolts are: HILTI “Kwik-Bolt”, Molly Parabolt or
similar.
1. Be sure lift is positioned correctly.
2. Drill holes in concrete the same diameter as anchor bolts, using anchor bracket
hole as guides. Depth is not critical – just drill sufficiently deep.
3. With nut and washer on anchor bolts, drive anchor bolts into holes so that a
minimum of six to seven threads are below the top surface of the anchor clips.
4. Tighten nuts securely. Be sure enough force is used to spread anchor bolt
wedges (usually 3 or 4 turns beyond ‘finger tight’).
5. After lift has been aligned, leveled and shimmed, and anchor bolts have been
installed, pour grout under entire base frame.
6. When set and cured, tighten nuts on anchor bolts.
7. Run hydraulic hose or electrical cord through conduit in pit wall.
Figure 12: Anchor Detail
INSTALLATION INSTRUCTIONS