Autoquip CAROUSEL WORK PLATFORM - Manual (Page 12)

12
Model Lowered
Height
(inches)
Travel
(inches)
Lift
Cap
(lbs)
Side
Load
Cap
(lbs)
End
Load
Cap
(lbs)
Base
Size
(inches)
Std.
Minimum
Platform
Size
(inches)
Max
Allowable
Platform
Size
(inches)
Lift
Weight
(lbs)
7220 8 72 2,000 1,000 500 58 X 96 72 X 102 72 X 168 4,000
8420 8 80 2,000 1,000 500 58 X 111 72 X 120 72 X 168 4,300
9620 12 96 2,000 1,000 500 58 X 140 72 X 144 72 X 168 4,500
NOTE: All models travel a speed of 20 fpm.
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to one side of the lift.
This figure is a net capacity rating for a lift furnished with the standard platform. The
relief valve of the pumping unit has been set to raise the weight, plus a small amount for
overload. Where equipment, special attachments, etc, are installed on the lift after
leaving the plant, deduct the weight of these from the load rating to obtain the net
capacity. Lifts should not be overloaded beyond the established capacity as
damage and/or personal injury may result.
UNBALANCED LOADING
The stabilization provided is basically for balanced loads. If special attachments extend
beyond the length and/or width dimensions of the platform, the end and/or side load
capacity must be reduced (contact an Autoquip Sales representative).
PUMP PRESSURE
This lift incorporates a positive displacement pump machined to a high degree of
accuracy and specially adapted to requirements of higher-pressure ranges over that of
a standard pump. Standard factory models of the same manufacture cannot replace it.
The pump can operate efficiently at intermittent pressures up to 3200 PSI and
continuous duty to 2500 PSI. However, the safety relief valve in the power unit is
factory-set considerably below 3,200 psi to stay within the parameters of the maximum
lifting capacity.
SPECIFICATIONS