Autoquip CAROUSEL WORK PLATFORM - Manual (Page 23)

23
14. Install the rod into the tube using care not to damage any seals or packing
15. Align the retainer hole in the bearing assembly groove with the slot in the tube.
16. Insert the retainer hook end in the hole/slot and using a face spanner wrench, turn
the bearing assembly clockwise until the retainer is completely inserted in the
groove/slot in the tube.
17. Check the clevis pin bushings in the cylinder rod for wear and replace as
necessary.
18. Install the assembled cylinder into the lift by carefully driving the clevis pin through
the clevis and cylinder rod. Extreme care must be taken to prevent damage to the
clevis in the bushings. Install the pin retaining screw with washers, engaging the
slot in the pin, and torque to 25 ft. lbs. or the retaining rings and washers on the pin
(cylinder rod may be extended by hand.)
19. Connect the cylinder hydraulic hose and the tee using the recommended sealant.
20. Check all pins and other mechanical as well as hydraulic components to assure
that the assembly is complete and in good working order.
21. Turn the electrical supply back on and press the “UP” button on the controller to
raise the lift. NOTE: 15 to 30 seconds time may elapse to fill the empty cylinders
before movement is noted.
22. Remove and place the maintenance leg in its storage location, then press the
“DOWN” button on the controller to cycle the lift to the fully lowered position. Hold
the “DOWN” button 30 to 40 seconds to allow air in the cylinders to bleed back into
the reservoir tank.
23. Cycle the lift 10 to 15 times and repeat the bleeding operation by holding the
”DOWN” button for 30 to 40 seconds.
24. Check the oil level in the reservoir with the lift in the fully lowered position. Add as
necessary (see “Routine Maintenance” for oil recommendations).
25. Clean the oil filler breather cap if it appears dirty.
26. Clean up any debris and or spilled oil from the area.
NOTE: Depending on experience, the job should take one to two hours.
GENERAL MAINTENANCE