Autoquip ABS AIR BAG LIFT - Manual (Page 12)

1. Make sure installation area is clean before starting.
2.
If the permanent air supply work is not complete, some means of temporary lines
with an on-off device for the air supply should be set up for testing purposes.
3.
Place the lift in the installation area.
CAUTION!
When moving the lift do not attempt to pick it up by the platform; it is
hinged and could be damaged. Pick up from under the base frame ONLY.
4. Make temporary air connections. Raise the lift to the top of its travel and make
positioning adjustments. Check for the proper height. If needed, shim to the
desired height.
WARNING!
INSTALLATION INSTRUCTIONS
To avoid personal injury, NEVER go under the lift platform until the load is
removed and the scissors mechanism is securely blocked in the open
position.
5.
If the lift is to be lagged to the floor, the base frame of the lift has pre-drilled holes
for lagging the lift. Mark the holes, drill, and install with anchors.
6.
Make permanent air connections and operate the lift through a few cycles.
CLEAN UP
1.
Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
2.
Touch-up paint is available from Autoquip for repair of damaged paint surfaces.
12