BAND-IT C00169 Hand Tool - Manual (Page 3)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P05886 rev. G
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 4
C00169 Hand Tool
Tool Assembly
Parts List
1. To assist in removing threaded parts, apply heat (softens locking compound).
2. When connecting the tension screw to the slide block, clean threads (male and female) of foreign
matter, then apply two drops of medium strength locking compound (Loctite 242 or equiv.) onto male
threads and connect parts together. Apply .03 oz. of food-grade white lubricant or equiv. to tension screw
thread.
3. When connecting the set screw to the cutter bar, clean threads (male and female) of foreign matter,
then apply one drop of medium strength locking compound (Loctite 242 or equiv.) onto male thread and
connect parts together.
4. Kit # C00689 contains the Tension Handle Assembly and the Tension Screw. Both parts should be
changed as a set to reduce accelerated wear. Review note 2.
5. Kit # C01899 contains the Band Gripper, Gripper Spring and Groove Lock Pin. Replace all parts as a
new set to maximize tool performance. Periodic cleaning of band gripper teeth will improve tool
performance.
6. Kit # C02499 contains the Slide Block, Groove Lock Pin, Band Gripper, Gripper Spring, and Tension
Screw. Periodic cleaning of band gripper teeth will improve tool performance. Review note 2.
TOOL FRAME
THRUST BEARING
SLIDE BLOCK
GROOVE LOCK PIN
BAND GRIPPER
TENSION SCREW
GRIPPER SPRING
SPIN GRIP
EXTERNAL RETAINING RING
EXTERNAL RETAINING RING
SCREW RETAINING RING
TENSION HANDLE
CUTTER BAR HANDLE
VINYL GRIP
SET SCREW
(On far side)
CUTTER BAR
SEE SHEET 4 FOR REPAIR PART NUMBERS
1