BAND-IT M50389 Multi Lok Tool - Manual (Page 5)

Installation Procedure Continued:
Open the tension handle slightly so that the 6.
knife retracts from its full stroke; it should be
overlapping the blade edge - Figure 5.
Using the edge of a table or bench, force the 7.
pull up lever against the blade. This will force
the blade against the knife and ensure a zero-
gap - Figure 6.
Tighten the cap screw 1/2 turn past snug.
8.
Tighten the set screw 1/2 turn past snug. 9.
Figure 5
Figure 6
M50389
Multi-Lok Tool
www. BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # M50350 rev. F
Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
Page 5 of 5
Blade Installation
Procedure