BAND-IT IT6000-AB 3/8 Tie-Lok Tool - Manual (Page 9)

Document # I17796 Rev F
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
9 of 38
IT6000-AB
3/8” Tie-Lok
® Tool
Setup &
Assembly
Instructions
Handle adjustment:
• Using 1/4” hex key (supplied), adjust
the Support Arm/Handle to
ergonomically match the operators
hand.
• Be sure not to adjust the Handle too far
outward (beyond interlocking legs) or
the handle will not function properly or
provide support to the operator.
Hanger Mount
Hanger Support Instructions:
1. An aluminum hanger (accessory
option) can be utilized for
supporting the tool.
2. The hanger should be installed (as
shown) into the two threaded holes.
3. Secure the hanger against the tool
body with the two supplied screws.
4. A light application of vibratite is
already included on the screw’s
thread.