BAND-IT UL4000-C Cordless Ultra-Lok Tool - Manual (Page 10)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P08986 Rev. A
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 10 of 14
UL4000-C
UL4000-C220
Ultra-Lok Tool
Clamp Inspection
Inspect buckle on completed clamp and tap down buckle shroud.
FRONT VIEW
Completed Free-End Clamp
(Visually inspect lock)
Buckle Shroud
Lock sheared in center
and formed inside
shroud
SIDE VIEW
Completed Free-End
Clamp
Tap down buckle shroud to
complete clamp
Completed clamp
should appear as
shown.
Important: Visually inspect lock formed in band as shown. If lock has slipped under the sheared surface of the
buckle, remove clamp and install a new one at reduced tension by lowering the Drill Clutch torque setting.
Shear Surface
Section View
Good Clamp
Bad Clamp
Lock has slipped back
under sheared buckle
surface
Figure 7
Figure 8