Battery Tender Waterproof 800 International - 12V @ 800 mA (PN 022-0150-DL-WH) Installation - Manual

DELTRAN BATTERY TENDER
®
WP800
Installation & Mounting Instructions
________________________________________________________________________________________________________
Deltran Corporation, 801 International Speedway Blvd., DeLand, FL 32724 Page
1 of 2
Phone 877-456-7901 FAX 386-736-0379 www.batterytender.com
LIKE POLARITIES MUST CONNECT TO BE SAFE.
Expos ed Pin
is Negative
Quic k Disc onnec t
same as used on
081-0069-6
Battery Tender Waterproof 800
Exposed Pin
is Pos itive
Covered Soc ket
is Negative
Cov ered Socket
is Positiv e
A utomotive Sty le Blade Fuse
3.0 or 7.5 A mp
Ring Terminals: A pprox
5/16" Ins ide Diameter
9/16" Outside Diameter
Fused Ring Terminals w ith
Quick Disc onnect
PN 081-0069-6
The Battery Tender® WP800 (Part # 022-0150-DL-WH) charger has an AC
power cord with a NEMA 1-15 plug (2-prong, no separate ground pin) that plugs
into a residential AC receptacle. The approximate AC power cord length is 6 feet.
There is no ON / OFF switch on the charger.
The DC output cord is a 2-wire, insulated cable assembly with a black, molded,
2 pin quick-disconnect plug on the end. That plug connects to a number of DC
output cable accessories.
The common DC output cable assembly accessories are: (Approx cable
lengths 18 inch min, 24 inch max.) Shown in order from left to right:
081-0069-6: Fused Ring Terminal Cable Assembly
081-0069-4: Fused Alligator Clip Cable Assembly
081-0069-5: Fused Cigarette Adapter Cable Assembly
Extension cables have the same cord configuration as the DC output cable connected to the
charger body. Each end of the cable extension has a black, molded, 2 pin quick-disconnect plug.
081-0148-25 Extension Cable, 25 ft long.
081-0148-12 Extension Cable, 12 ft long.
The following connection rule applies for DC cable assemblies and the black, molded, 2 pin quick-
disconnect plug.
If the DC cable is directly connected to the body of a charger, then the exposed pin is connected to
POSITIVE voltage at the charger output.
The same will be true for the exposed pin on the end of an
extension cable when the other end of the extension cable is connected to the charger DC output cable.
DC cable assembly accessories are designed so that the rings, clips, or the cigarette adapter connect to a
battery.
The exposed pin on a DC cable assembly accessory is connected to NEGATIVE OR
REFERENCE voltage at the battery. Again, the same will be true for the exposed pin on the end of
an extension cable when the other end of the extension cable is connected to a DC cable assembly
accessory.