Battery Tender Plus GEL 12V @ 1-25A (PN 021-0156) - Manual

DELTRAN BATTERY TENDER
®
PLUS
Installation & Mounting Instructions
________________________________________________________________________________________________________
Deltran Corporation, 801 International Speedway Blvd., DeLand, FL 32724 Page
1 of 2
Phone 386-736-7900 FAX 386-736-0379 www.batterytender.com
The Battery Tender® Plus charger has an AC power cord with a NEMA 5-15 plug (3-
pins, including ground) that plugs into a grounded, residential AC receptacle. The
approximate AC power cord length is 6 feet. There is no ON / OFF switch on the
charger.
ON THE 12 VOLT MODELS ONLY: The DC output cord is a 2-wire, insulated cable assembly with a
black, molded, 2 pin quick-disconnect plug on the end. That plug connects to a number of DC output cable
accessories. The approximate DC output cable length is 4.5 feet. The UL-1236 Standard requires a total of
12 feet from the AC mains wall receptacle to the battery terminals. The total cable lengths are AC cord
6 feet + DC output cord 4.5 feet + DC Cable Assembly Accessory 1.5 feet (18 inches minimum).
FOR THE 12 VOLT MODELS ONLY: The common DC output cable assembly accessories are:
(Approx cable lengths 18 inch min, 24 inch max.) Shown in order from left to right:
081-0069-6: Fused Ring Terminal Cable Assembly
081-0069-4: Fused Alligator Clip Cable Assembly
081-0069-5: Fused Cigarette Adapter Cable Assembly
FOR THE 6 VOLT MODELS ONLY: The common DC output cable assembly accessories are:
(Approx cable lengths 18 inch min, 24 inch max.) Shown in order from left to right: Notice the white
connectors on the accessories for the 6 Volt BT Plus.
081-0069-6W: Fused Ring Terminal Cable Assembly
081-0069-3: Fused Alligator Clip Cable Assembly
There is no Cigarette Adapter Cable Assembly
FOR THE 12 VOLT MODELS ONLY: Extension cables have the came cord configuration as the DC
output cable connected to the charger body. Each end of the cable extension has a black, molded, 2
pin quick-disconnect plug.
081-0148-25 Extension Cable, 25 ft long.
081-0148-12 Extension Cable, 12 ft long.
The following connection rule applies for DC cable assemblies and the black, molded, 2 pin quick-
disconnect plug.
If the DC cable is directly connected to the body of a charger, then the exposed pin is connected to
POSITIVE voltage at the charger output.
The same will be true for the exposed pin on the end of an
extension cable when the other end of the extension cable is connected to the charger DC output cable.
DC cable assembly accessories are designed so that the rings, clips, or the cigarette adapter connect to a
battery.
The exposed pin on a DC cable assembly accessory is connected to NEGATIVE OR
REFERENCE voltage at the battery. Again, the same will be true for the exposed pin on the end of an
extension cable when the other end of the extension cable is connected to a DC cable assembly accessory.
The 25 & 12 ft extension cords WILL NOT
directly connect to the 6 Volt BT Plus