Online manual not for resale purposes – BLITZ Dual SBC Spec R & S User Manual

Page 5

Advertising

TURBO SYSTEM EXAMPLES

Actuator type set up

the out port on the turbo to the in port of the solenoid.

Vehicles equipped with stock solenoids

TO STOCK SOLENOID

FACTORY "T" FITTING

connected to factory electrical harness.

After this procedure is complete, follow the instructions above for the actuator type set up.

IMPORTANT

: For Actuator setup, please be sure that AC is set on back of the controller

Remove the stock hose which connects the actuator to the turbo. Use the supplied rubber hose
to connect the actuator port to the out port of the solenoid. Use the supplied rubber hose to connect

For vehicles equipped with stock a stock solenoid, locate the factory T and remove the factory solenoid line
from the factory "T". The cap off the stock solenoid line. Leave the factory solenoid in the vehicle still

ACTUATOR

IN port

OUT port

ACTUATOR

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this may be

reproduced, stored in retrevial systems, or transmitted in any form or means with out prior written permission of

Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals