Online manual not for resale purposes – BLITZ Dual SBC Spec R & S User Manual

Page 6

Advertising

Dual port actuator set up

Leave the factory solenoid in the vehicle still connected to factory electrical harness.

After this procedure is complete, follow the instructions on the previous page for the actuator type set up.

External wastegate set up

The bottom port of the wastegate ( B ) should be connected to the turbo.

Use supplied hose clamps to prevent pressure leak.

IMPORTANT

: For External Wastegate setup, please be sure that WG is set on back of the controller

Cut the hose between stock solenoid and dual port actuator. Cap off both ends of the hoses.

Connect a pressure port from before the throttle body to the IN side of the solenoid unit.
The solenoid unit out port will connect to the top port of the external wastegate ( A ).

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this may be

reproduced, stored in retrevial systems, or transmitted in any form or means with out prior written permission of

Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals