Black & Decker TROS1000Q - Manual (Page 6)

0 
Important: Do not put mounting hooks on hood through the mounting tabs on
the oven. You must hook the tabs up and over the hooks to properly hold.
13. Once the back hooks are secure, hook your fingers around the feet on the front
of the toaster oven (G). Pull forward and push up on the feet at the same time
to engage the front hooks.
14. Plug into standard electrical outlet. Extra cord can be hung over cord
management hook behind unit (H).
Warning: Risk of electrical shock and fire. Do not allow cord to touch rear
surface of oven.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Note: If you are connecting another †SpaceMaker™ appliance into the Save-A-
Plug™ outlet, make sure you can easily unplug the appliance after each use.
12. Your †SpaceMaker™ appliance is now ready for use!
OVERHANG MOLDING INSTALLATION
For cabinets with an overhang molding (see Illustration C)
Important: Always wear protective glasses or goggles to prevent injury when
drilling.
Note: Spacers are provided in case your cabinet has an overhang molding at the
front edge. Only use spacers on the rear screws of the appliance to ensure it is
level with the front.
H
cabinets during mounting. Drilling through your cabinet’s partition may cause
damage to cabinets and prevent proper installation.
4. Fold the template along the edge of your cabinet so the thick line is straight
with bottom front edge; pull template tight and tape down to hold in place.
5. Drilling from under the cabinet up, drill holes through the 4 places marked on
the template, using a ¼-inch drill bit (E).
Important: Always ensure you are drilling straight up through the marked
mounting hole on the template. Drilling at an angle may prevent proper
installation and may damage cabinets if the drill bit pierces the partition.
6. Once holes are drilled, remove tape and mounting template.
7. Wipe dust and debris off the topside and underside of the cabinet surface.
8. Place a washer inside the cabinet over each of the 4 holes you drilled.
9. Hold hood in place, aligning front of hood with front edge of cabinet; drilled
holes on cabinet should be aligned with mounting holes on the hood.
10. Drop one of your screws through each of the washers covering the holes in the
cabinet, from inside the cabinet down.
Note: To determine which screws to use, you must have enough of the screw
exposed underneath the cabinet to properly thread the screw into the nut.
11. Screwing from inside the cabinet down into holes, tighten 4 screws in place to
secure hood to cabinet.
Note: Always tighten screws to ensure the appliance does not move or shake
during operation.
12. After the hood is secured, lift the toaster oven up to mount. Hook the mounting
tabs on the back of the oven over the mounting hooks at the back of the hood
(F).
F
G
E