Carlin 102CRD-99FRD-100CRD - Manual (Page 28)

Model 99FRD, 100CRD & 102CRD oil burners — Instruction manual
Carlin part number MN99102 Rev. 10/21/10
– 28 –
For other than routine maintenance, contact
a qualifi ed service company. Perform the
following as needed.
• Keep the area around the burner clear
and free from combustible vapors and
liquids.
• Do not obstruct the fl ow of combustion
and ventilating air.
• Most motors currently used on residential
type burners use permanently-lubricated
bearings, and do not require fi eld lubri-
cation. Read the label on the motor to
determine oiling needs, if any. Do not
over-lubricate. This can cause as much
trouble as not lubricating at all.
Never attempt to use gasoline as
a fuel for this burner, as it is more
combustible and could result in a
serious explosion. Never attempt to
burn refuse or use any fuel other
than # 1 or # 2 heating oil (ASTM
D396).
99FRD, 100CRD, and
102CRD oil burner
User care and maintenance
Refer only to the information on this
page, intended for your use. The
remainder of this manual is intended
only for your service technician.
Failure to comply could result in
severe personal injury, death or
substantial property damage.
Should overheating occur:
(1) shut off the oil supply to the burner.
(2) DO NOT shut off the control switch to the
circulator or blower.
(3) contact your oil dealer or service techni-
cian and the fi re department (if needed).
The burner must be cleaned, tested and
adjusted annually by a qualifi ed oil burner
service technician.