CCTV Camera Pros iDVR-PRO A Series DVRs - Manual (Page 34)

System Setting
34 |
System Setting
\ \ Motion Sensor
Set the motion sensor of the camera so that it can detect a motion event.
1. From <SYSTEM SETUP> - <CAMERA>, select
<MOTION SENSOR>.
2. Use the [ ▲▼◀▶ /ENTER] buttons on the remote
control or use the mouse to specify the use of each
option item.
i
ACTIVATION : turn on or off the motion sensor.
i
MARK : Set to <ON> to display the motion
detection indicator on each video tile where
applicable.
i
SENSITIVITY : Set the sensitivity level of the
motion sensor to either Daytime or Nighttime.
i
EDIT AREA : Specify the motion detection area.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The confirmation
message appears and you will return to the previous menu.
J The motion detection sensitivity may differ depending on the characteristics of the connected camera or the installation environment.
Motion Area Setup
From the motion setup window, click <EDIT AREA> in the right corner to display the area setup screen.
Setting the motion area may differ depending on the camera model. Below is a typical setting of the motion area.
1. Click <EDIT AREA> to move to the motion area
setup screen.
2. If using the remote control, press the [ENTER] button
to mark the current position.
3. Use the arrow buttons to move to a desired block and
press [ENTER]. The area setup will begin.
Then, use the arrow buttons to specify the area.
 Alternatively, you can use the drag-and-drop method to
specify or release the area as using mouse.
4. If you select the specified area again, it will be
released.