COATS 1100 Series Balancer User Manual
Page 12
8 •
Important: Always read and follow instructions.
Figure 12 - Control Panel Feature Reference (Model 1150 Shown)
Control Panel Layout
7
7
4
4
6
6
5
5
3
3
2
2
2
2
1
1
Control Panel Function and Review
1
1
Weight Display Windows
Two weight display windows, one Inboard and one Outboard, are positioned above the Wheel Cross-section
Diagram. After a wheel measurement cycle, the balancer calculates the corrective weight amount and indicates
it in the appropriate display window. All weight readings are shown in Ounces or Grams. Also displays A, W,
and D values, functions, and instructions for the operator. Error messages will also be shown in this display.
The Total Static window indicates the value of the total static unbalance. See MATCH BALANCE (Optimization)
on page 16 for further details.
2
2
Weight Position Bars
Located on either side of the wheel cross-section diagram are the weight position bars, one Inboard and one
Outboard. After a measurement cycle, rotate wheel until the center weight position bar blinks, indicating the
correct weight placement position is at top-dead-center.
Key Group
If you press/select ...
Then indicator illuminates/displays...
3
3
Direct Select™ Weight Keys & Wheel Cross-section Diagram
, or
Clip 1, or T1 Tape
the activated Inboard weight location
on the wheel cross-section diagram.
,
or
T2 Tape, T3 Tape or Clip 2
the activated Outboard weight location
on the wheel cross-section diagram.
4
4
Wheel Dimensions (DIM) Keys & Measurement Diagram
,
, or
A, D, or W
the activated wheel measurement
location. The default is Clip 1 and Clip 2.
Enter wheel data manually using either
the Up or Down arrow key.
+
or
+
A2+Function or D2+Function