COATS HIT 5000H2 Truck Tire Changer - Manual (Page 14)

Demounting
1. By operating the carriage to the extended posi-
tion, the table will be rotated to the horizontal position.
2. Place the tire and rim over the table top by rolling
into place and then leaning back onto the table.
3. Again, using carriage handle, rotate table back to
vertical position. As this occurs, the tire and rim will fol-
low and end up sitting on top of the table.
Ensure that table cylinder is retracted when
the above operation is done so there will be
no damage to the cylinder shaft.
4. When the table is in the vertical position, manually
center the tire and rim so that it lies perpendicular to
the table cylinder.
5. Place the tire compressor on top of the tire and
pin it to the clevis affixed to the table cylinder.
Adjust the four arms of the compressor to
just clear the lock ring. Tighten all of the "T"
handles so they won't move.
Ensure at this point that the tire has been
completely deflated and the valve core
removed from the valve stem.
6. Compress the retaining ring and tire down enough
to clear the lock ring. Using the ring tool, remove the
lock ring.
7. Extend the table cylinder and remove the com-
pressor, lock ring, retaining ring and rim seal.
8. Rotate table to the horizontal position. Remove
tire and rim, then replace them after turning them 180
degrees.
9. Rotate table back to vertical position.
Note: Rim face should now be on bottom.
10. Reinstall compressor and pin it to the clevis
affixed to the table cylinder.
WARNING
CAUTION
CAUTION
H.I.T. 5000H2
8 • COATS H.I.T. 5000H2 Changer
Hutchinson Run Flat Tires