COATS HIT 5000H2 Truck Tire Changer - Manual (Page 17)

H.I.T. 5000H2
COATS H.I.T. 5000H2 Changer • 11
9. Place the combo tool "tee" into the carriage with
the "tee" perpendicular to the carriage cylinder and plat-
form on the side facing outer tire. Also, extend carriage.
10. Start inner tire into outer tire and place lower
end onto platform on side of combo tool "tee".
11. Move carriage rearward, retract, and push inner
tire into outer tire.
12. When inner tire is inside outer tire, use release
rod by hooking over release bar on strap clamp as
shown above.
13. After ensuring that everything and everyone is
clear, release strap with quick pull on release rod.
Inner tire will expand rapidly, and with much
force. Ensure that release rod is used when
releasing catch. FAILURE TO DO SO COULD
RESULT IN SERIOUS INJURIES.
14. Remove short web strap from inside of outer
tire.
15. Lower both tires to carriage and remove from
machine.
16. Extend carriage, rotating table to horizontal posi-
tion.
17. Place rim over table top and tire over cylinder
shaft. Apply liberal amount of tire lube to rim as shown
above.
18. Extend table cylinder shaft fully. Now retract car-
riage cylinder and rotate table, tire and rim to vertical
position.
19. Place retaining ring over cylinder shaft. Now
install compressor onto clevis affixed to rod end of
table cylinder.
20. Press both tires down over rim. Push tire down
below lock ring groove.
WARNING