Brother DCP-540CN - Manual (Page 73)

Troubleshooting and Routine Maintenance
67
c
Open the new ink cartridge bag for the
colour shown on the LCD, and then take
out the ink cartridge.
d
Remove the protective yellow cap (1).
Improper Setup
DO NOT touch the area shown in the
illustration below.
Note
If the protective yellow caps come off
when you open the bag, the cartridge will
not be damaged.
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Lift the lock release lever and push it
until it clicks, and then close the ink
cartridge cover.
g
If you replaced an ink cartridge the LCD
may ask you to verify that it was a brand
new one. (For example, Did you
change Black
) For each new
cartridge you installed, press + (Yes) to
automatically reset the ink dot counter
for that colour. If the ink cartridge you
installed is not a brand new one, be sure
to press - (No).
If you wait until the LCD shows Near
Empty
and Ink Empty, the machine
will automatically reset the ink dot
counter.
Note
If the LCD shows No cartridge after
you install the ink cartridges, check that
the ink cartridges are installed properly.
1
M
brother
XXXX