Operating instructions – COATS Kit 85607770 Tire Inflation Cage User Manual

Page 7

Advertising
background image

COATS

• 7

Tire Inflation Cage Kit Setup

1.

Disconnect tire changer from power source and

from its air supply. Bleed off all air pressure. Verify the

stored air pressure is zero by observing the air pressure

gauge.

2.

Remove cage and parts from pallet and determine

which attachment position to use (angled or straight).

3.

Assemble protectors and attachment brackets in

the appropriate location to achieve desired attachment

position.

4.

Attach cage to tower using two U-bolts in desired

attachment position.

5.

Build inflation / bracket assembly and attach to

cage (see parts identification).

6.

Connect nozzle and hose assembly; build up sup-

ply assembly and connect to inflator gauge (see pneu-

matic diagrams).

Note: Use thread seal compound on non-precoated

fittings.

7.

Route hoses and electrical connection as shown.

Tie to cage.

8.

Connect inlet air to cage inlet and cage inlet to

changer. Turn on air supply and connect electrical plug

to 110V service.

Operating Instructions

Using Tire Inflation Cage

1.

Always keep the floor clear of dirt and debris inside

and around the cage area.

2.

Be sure to clean tire and rim of any loose debris.

3.

Using tire changer, follow tire changer instructions

to bead seal tire on rim. After bead seal is achieved,

remove clip-on chuck and reinstall the valve core if it

was removed.

4.

Roll the tire assembly into the cage. Center the

tire, in the cage, in an upright position. Rotate tire so

inflation valve is between inflation cage tubes.

5.

Press

or

button on autoflate to

set desired pressure. Connect the inflation hose with

the clip-on chuck to tire valve stem and inflation will

begin automatically.

Note: Press the

button if inflation does not

automatically start.

IMPORTANT: When the set pressure is greater than

40 PSI the unit will inflate to 40 PSI; and then prompt

you for confirmation to proceed. Check tire and press

any button to complete tire inflation procedure greater

than 40 PSI.

6.

DO NOT STAND IN TRAJECTORY ZONE DUR-

ING INFLATION. When inflation is complete, the auto-

flate unit will beep and the pressure will flash on the

display.

Inspect Tire Inflation Cage Monthly

INSPECT cage for damage. Loose or weakened parts

can fly in a tire explosion.

DO NOT USE cage if tubing is visibly bent, or shows

visible cracking at welds.

Advertising