Wheel lift installation instructions – COATS Wheel Lift for use with 9024E Rim Clamp Tire Changer User Manual
Page 2
2 • COATS Tire Changer Accessory
Wheel Lift Installation
Instructions
Important: Before proceeding with the
installation of the Wheel Lift, perform the
following pre-installation operations to
provide higher safety conditions both to
the operator and to the tire changer.
Failure to perform these pre-installation
operations may result in accidents com-
promising machine integrity, operator and
by-standers.
Pre-Installation Operations:
• Close the turntable clamps completely.
• Set the vertical arm in working position.
• Lower the operating arm completely and lock it.
• Turn OFF both electrical and pneumatic feeding.
• Let residual air out from pneumatic circuit by per-
forming some loadless bead-breaking operations.
Wheel Lift Components
Front Pedals Cover with built-in Wheel Lift
UP/DOWN Movement Control
Screws and Unions
-
Screws 6x12
-
Washers 6, 5 x 18 x 1, 5
-
T-union
-
Cable Tie
Wheel Lift Assembly
Installation Procedure
1. Unscrew the 4 screws and washers (set aside)
and remove the side cover. (Fig. 2, 3, & 4)
3
2
1
1
2
3
5
Fig. 4
5
Fig. 3
5
Fig. 2