COATS Wheel Lift for use with 9024E Rim Clamp Tire Changer User Manual
Page 6
6 • COATS Tire Changer Accessory
17. Using the remaining screws and washers, fas-
ten the pedal cover to the body. (Fig. 24)
18. Replace the side cover and fasten it to the
body using the screws and washers side aside. (See
Fig. 25)
Operational Check
Important: Before performing the final test
of the Wheel Lift, ensure the following to
maintain machine and user safety:
•
That no by-standers stand in the range
of action of the tire changer.
•
That the clamp opening/closing pedal
is in closing position.
•
That the operating arm is locked.
1. Reconnect both electrical and pneumatic sys-
tems.
2. Wait a few seconds for the pneumatic circuit air
filling.
3. Press Wheel Lift UP/DOWN control and see if
the movements correspond to the desired action.
Technical Data
5
Fig. 25
5
Fig. 24
5
Fig. 26
Operating Pressure
145 PSI / 10 Bar
Lifting Capacity
110 lbs. / 50 kg
Net Weight
46.2 lbs. / 21 kg