Comelit MT 3451 - Manual (Page 25)

25
WELCOME MESSAGE
YES
*NO
OK OK
SCROLL ESC
STATIC MESSAGE
YES
*NO
OK OK
SCROLL ESC
SCREEN SAVER
YES
*NO
OK OK
SCROLL ESC
SECOND LANGUAGE
CALL MANAGEMENT
ACCESS CONTROL
NAME ONLY
OK OK
SCROLL ESC
WELCOME
SCROLL OK
ESC CANC
KEYPAD SENS.
LOW
*MEDIUM
HIGH
OK OK
SCROLL ESC
EN
2.7. Name only
2.8. Welcome message
This function is disabled by default.
Allows only the name to be displayed, without the user code,
when scrolling through the directory and during a call from a user.
This function (not enabled by default) can be used to enter a welcome
message (MAX. 40 characters over 4 lines, in block capitals).
The welcome message alternates with the normal information screens
every 4 seconds.
N.B.: the message cannot be switched to the second
language when the "SECOND LANGUAGE" function is on
(see section "2.4 Second language").
1. Access programming mode, see page 17.
2. Select settings/name only.
3. Select:
YES
NO (default)
4. Confi rm.
1. Access programming mode, see page 17.
2. Select menu options: settings/welcome message/change.
3. Enter the welcome message.
4. Confi rm.
or:
Delete the existing message and enter a new message.
2.8.1 CHANGE
It is possible to enter the welcome message using software Art. 1249B.
1. Access programming mode, see page 17.
2. Select: settings /welcome message/enable.
3. Confi rm to enable the message.
2.8.2 ENABLE
The "initial message" function is disabled by default.
If activated, the welcome message will appear and remain on the
display after a 30-second period of inactivity.
2.9 Screensaver
If this function is enabled (it is disabled by default), the screensaver will
appear after a 30-second period of inactivity.
3. Select:
YES
NO (default)
4. Confi rm.
1. Access programming mode, see page 17.
2. Select: settings/welcome message/static message.
1. Access programming mode, see page 17.
2. Select: settings/screen saver.
2.8.3 STATIC MESSAGE
The "initial message" function is disabled by default.
If activated, the welcome message will appear and remain on the
display after a 30-second period of inactivity.
3. Select:
YES to enable the function.
NO to disable the function.
4. Confi rm and/or press to exit.
2.10 Keypad sensitivity
1. Access programming mode, see page 17.
2. Select: settings/keypad sens.
This parameter can be used to set how sensitive the keypad is to being
touched.
3. Choose between:
4. Confi rm.
low
medium (default)
high