Comelit MPTZ766A - Manual (Page 23)

17
3.4 Auto Scan
The Auto Scan supports up to 5 programmed angles at user-programmable speeds. Follow
these steps to program Auto Scan:
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
SPEED : 05 STEP
START ANGLE : ----- -----
END ANGLE : ----- -----
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
SAVE AND EXIT(ESC TO CANCEL)
NUMBER : 01 ~ 04, 09:AUTO PAN mode.
TITLE
: up to 12 characters.
SPEED : 01 ~ 13 step, the lower number means the slower speed.
SCAN DIR : Set the Scan direction, CCW(Counter Clock Wise), CW(Clock Wise).
SWAP
: Swap the start point for the end point.
DWELL : Set the dwell time at the both end, 01 ~ 99 seconds.
1. Press the MENU key to display the main menu on the monitor. Scroll to Auto Scan and push
the Joystick to the right.
2. Select “NUMBER” and set the desired number by pushing the Joystick to the left or right.
3. Select “TITLE” and twist the Joystick to enter the title edit mode.
4. Twist the Joystick by changing the alphanumeric characters and move the next position. Or
move down to the character table and press the CTRL or IRIS Open key at the desired
character then the cursor position moves to the next position automatically. Push the Joystick
to the left or right at the “ALL DELETE” field to delete all characters. Push the Joystick to the
left or right at the “EXIT” field to finish title edit menu.
TITLE EDIT MENU
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT(ESC TO EXIT)
5. Select “START ANGLE”. Hold down the CTRL key while selecting the start position using the
Joystick. Current panning position will be displayed. Release the CTRL key to complete the
selection of the start position. Or press the IRIS Open key then the “CTRL” displays. Move the
desired position and the zoom position. Press the IRIS Close key then the “CTRL” disappears.