Comelit MPTZ766A - Manual (Page 26)

20
3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (1 to 120), and press the CTRL and PRST keys
subsequently. The current view will be stored to the selected Preset number if the Preset number
is empty. If selected Preset number is not empty, “OVER WRITE” message will be displayed on
the monitor and select the “OK” and push the Joystick to the right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST keys will store current view as Preset no. 101. In this case,
focus will be programmed as Auto, dwell time will be set to 3 second, and the current
AE mode will be programmed.
3.7 Tour
There are 4 programmable Tours. Each Tour consists of up to 42 Preset positions.
TOUR SETUP
NUMBER : 01
TITLE : T01
SPEED : 05 STEP
DWELL : -- SEC
001 002 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- 003 --- --- --- ---
--- 004 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- --- --- --- --- ---
SAVE AND EXIT(ESC TO CANCEL)
--- : blank position
DWELL : 03 ~ 99 SEC
001 : Preset (1 ~ 120)
Follow the steps below to program the Tours:
1. Press the MENU key to display the main menu on the monitor. Scroll to Tour and push the
Joystick to the right to enter the Tour menu.
2. Select “NUMBER” and set the desired number by pushing the Joystick to the left or right.
3. Choose a blank position to be programmed by pushing the Joystick up, down, right, or left.
4. To add a stored Preset, twist the Joystick then the stored Preset number displays.
5. You can also overwrite the programmed number and to remove a stored number from the
Tour, press the HOME key on the stored number, a blank position mark (---) will be displayed.
6. Repeat step 2 through 4 for each desired position. Each title will be displayed on top of the line.
7. To edit the “TITLE”, follow the procedure of the Auto Scan above to edit titles.
8. Select “SAVE AND EXIT” and push the Joystick to the right or press the IRIS Open key.
Press the ESC or IRIS Close key to exit the program without saving.