CounterPath Bria 3.5 Administrator Guide - Manual (Page 36)

CounterPath Corporation
32
When the user chooses View >Workgroup, Bria immediately registers attempts to subscribe to the workgroup.
If the subscription succeeds, the Workgroup window appears in Bria.
The Workgroup window will show the following:
Configuring in Peer-to-Peer Mode
In this mode, you have two options:
• If you are deploying through provisioning, you can create workgroups and set up members in members
through your provisioning response, as described in the “Bria 3 Configuration Guide – Retail
Deployments”. However, you may still want to configure a workgroup manually yourself before setting up
through provisioning.
• If you are deploying manually, users must perform their own setup, as described in the user guide.
However, you may want to set up a workgroup yourself, as a dry run.
Setting up as a Regular User
Typically, everyone in a group will informally agree to add each other to their group so that everyone’s setup
contains the same workgroup members.
1. Set the Mode to Peer-to-peer.
2. Select the monitoring method:
• Allow anyone to monitor my call activity: if you want everyone in the workgroup to monitor you.
Normally, you choose this mode.
• I will choose who can monitor me: if you do not want to let everyone in the workgroup to monitor you.
(for example, if you are a supervisor; see below for details). Or if you only want one person to monitor
you.
3. Click Edit Members. On the Workgroup Members window click Add. In the Add Workgroup member
window, enter a person’s SIP address as shown. Repeat for all the members of the workgroup.