Dascom DT-230 User Guide - Manual (Page 18)

Tally Dascom DT-210/230
7
1.6 Adjusting paper near end sensor
Open the printer cover. You will see a black lever inside as shown below.
The printer has a paper near‐end sensor that provides notice that the paper roll is nearly exhausted.
When the paper is running low, the paper LED is lit red.
If you find that there is not enough paper remaining on the roll when the near‐end sensor is
triggered, you can change the near‐end sensor setting.
Adjustments:
The paper near end lever is continuously adjustable from “1” to “6”.
1. Minimum paper remains until paper end. (Paper roll diameter about 26mm)
2. Paper remains until paper end. (Paper roll diameter about 27mm)
3. Paper remains until paper end. (Paper roll diameter about 28mm)
4. Paper remains until paper end. (Paper roll diameter about 30mm)
5. Paper remains until paper end. (Paper roll diameter about 32mm)
6. Maximum paper remains until paper end. (Paper roll diameter about 33mm)