Dascom 7010 Cutter Installation Guide - Manual (Page 3)

– 3 –
Installation Guide
Side view
Hook
Top cover
Front top cover
(1) Check to make sure that the printer’s power switch is turned off then disconnect the
power cord.
(2) Open the top cover and lift the thermal printhead and sensor arm.
(3) Remove the front top cover from the top
cover. (2 screws)
Note There is a hook on the front top cover.
Be careful not to bend the hook while
removing the front top cover from the
top cover.
(4) Remove the cutter attachment cover from
the front top cover that you have removed.
Note The cutter attachment cutter that
you have removed is used to remove
the auto-cutter unit, so store it
carefully.
Thermal printhead
Head open lever Sensor arm open lever
Sensor arm
Cutter attachment cover
CAUTION: For use by service representatives!