Dascom T2280+ Web Panel Description - ETH-INT - Manual (Page 4)

© DASCOM Europe GmbH Version 1.0 Page 4 of 25
2. Static assignment using the operator panel:
• Press <Setup>, then <Menu>.
• Press <Next> until the I/O selection appears. Select <I/O>.
• Press <Next> until the ETH-INT selection appears. Select <ETH-INT>, then<IP Addr>
• Enter the value for Octet 1by pressing <OCTET 1>. Use the forward and backward
arrows to increment/decrement the number. When finished with each entry press <Set>
which will set the currently displayed value. To exit out without changing the value press
<Exit>. Enter the Octet 2 value in the same way, pressing <OCTET 2>. To get to Octet
3 and Octet 4, select <Next> and then select <OCTET 3> and <OCTET 4>.
• Enter the default Gateway and Subnet mask in the same way. <Gateway> is available
from the screen you are returned to. Press <Next> to select <Subnet>.
• Enter the IP address get method under the selection <IP Get M>. Select <Static>.
3. BOOTP IP address assignment:
• Press <Setup>, then <Menu>.
• Press <Next> until the I/O selection appears. Select <I/O>.
• Press <Next> until the ETH-INT selection appears. Select <ETH-INT>.
• Press <Next> until the IP Get M selection appears. Select <IP Get M> Select <BOOTP>
• Obtain the Ethernet MAC address by printing the “Current Settings” configuration page.
Turn off printer.
• Configure your BOOTP server with desired IP address and MAC address.
• Turn on printer.
• Verify that the printer network interface received an IP address by printing the “Current
Settings” configuration page or in the operator panel menu.