Dascom TallyCom III Installation & Operators Guide - Manual (Page 50)

Appendix D. Test Printout Pages
D.1 Test 2: Online Hex Dump (Coax)
Note: The PCIA (printer controlled information area) is the first 5 rows in the ON-line Hex dump.
Mode = LU1 mode. Msg st addr: 0473 Msg lng: 0087 First segment in chain.
Receive state. SA control valid. Normal SCS data streams.
See Related Manuals in the Introduction for further information on the original IBM manuals.
D.2 Test 4: Settings Printout
Printserver – FSL Settings
TallyCom III Coax IIF-4 10/100
Firmware Rev. S12 256.020/01460020. Chk: 9BEB.
Boot id: 80001007
LU1 Character Set: Downloaded
Printer Driver: EPSON LQ
Escape code = 00 Hex, Character = ‘ ‘,’&&??’.
Dynamic area size: 4096 bytes,
170 bytes used, 3926 bytes free.
Buffer size
# 1 4
LPI # 2 6
CPI # 3 10
Linespacing # 4 1
MPL # 5 72
MPP # 6 132
50