Elkhart Brass Unibody Valve - Manual (Page 19)

19
800.346.0250 • www.elkhartbrass.com
A) Non-Slow Close Handle Positioning
1. Remove the 1/2" bolt and washer that locks the handle in position.
Figure 16
2. The spring-loaded assembly will urge the handle off the actuator shaft. Remove the
handle completely from the shaft and rotate to the desired location in 45° increments.
Figure 17
3. Place handle back on actuator shaft in new location and reattach washer and 1/2" bolt.
While tightening bolt, ensure that the stop plate tabs line up with slots in adapter plate
as shown.
Figure 18
Remove handle
and rotate in
45° increments
Bearing break tab drops
into slot on adaptor plate