Elkhart Brass Unibody Valve - Manual (Page 47)

47
800.346.0250 • www.elkhartbrass.com
Figure 45. Saddle Clamp Installation
Note: Allow a minimum of 2 inches
clearance at the sensor top for removal/
installation of the connector.
Note: When the retainer cap is tightened
make sure the sensor rim flat spot does
not disengage from the alignment tab and
allow the flow sensor to rotate.
Note: These dimensions are typical and are
given to be used as an aid in determining
mounting locations for flow sensors.
Pipe Size Dimensions
(Sch 40) A B C
2 5.5 3.9 2.9
2.5 5.5 3.9 2.8
3 5.9 3.9 2.8
3.5 6.8 4.3 2.8
4 6.8 4.3 2.8
5 8 4.3 2.8
A
C
B
Retainer
Cap
O-Ring
Paddlewheel Flow
Sensor
Sensor
Housing
Saddle
Clamp
Alignment Tab