Elkhart Brass Unibody Valve - Manual (Page 20)

20
ELKHART BRASS MANUFACTURING COMPANY, INC
Roll pin
B) Slow Close Handle Positioning
A slow close is available for the R1S, R2S, D1S, D3S and S1S actuators.
1. Properly position the handle. See page 19 - Non-Slow Close Handle Positioning
2. Determine the position of the roll pin alignment. Ensure that the handle will not be
obstructed from moving to full open and full close positions when installed.
Figure 19
3. Remove the 1/2" bolt and washer that locks the handle in position.
Figure 20
4. Drive the roll pin into an appropriate stop.
Figure 21
Handle moves freely
Pin alignment